Hi Stephane! Reporting a benign, arbitrary bug I found when I made a new box primitive, I was reducing the topology (Division X) to low figure, got to 0, and from there the slider reacts but the increment retained a 0 reading - if I manually input a figure, the slider works as it should until I go b…

Slight update, seems to happen at a threshold of below 3 universally, I went to resume my sculpt and found that I had to manually input a figure higher, 4 onwards is fine.

Just had a read, didn’t see this section in the forum - ideal! Thank you

Topology Division Bug

Bug Report

stephomi September 4, 2021, 10:11pm 3

You can see the logs about sliders Nomad Change Log - #32 by stephomi

Topic		Replies	Views
Nomad Sculpt Topology Issue Cube? Bug Report	3	787	August 28, 2021
Keep topology clean & save Bug Report nomadsculpt	0	251	November 5, 2022
Dynamic topo not working Bug Report	10	1121	January 25, 2022
8-sided division Feature Request	5	1533	January 19, 2022
Dynamic Topology problem Bug Report	2	458	August 31, 2020

Topology Division Bug

Related topics