Torus - rotation option

[Holger_Schoenischka]

Could the Torus also have a rotation? For low divisions, this would be practical.

I can only dream of twist….

[ray]

Probably best would be if the torus would be a “tube primitive”.
Although that would need 2 validate buttons then (validate curve and validate mesh)

[stephomi]

Just use the tube with the loop option and square profile.

[Holger_Schoenischka]

Unfortunately, you cannot set circular angles for cake pieces with the tube, it is also no longer possible to make beautiful uniform rings with the tube, the trim path from the circle can no longer be used for this.